High strength - often giving a bond stronger than the materials being bonded
Small parts bonding
Handy Hints:
To improve adhesion to difficlut to bond materials e.g. PE, PP, PTFE, TVP or thermoplastic rubbers; in combination with LoctiteŽ 401, 406, 431, 454, 480 or 4850 - use Primer LoctiteŽ 7239
For difficult to bond plastics PE and PP, look also at LoctiteŽ 3030 Polyolefin Bonder
To increase the cure speed of Instant Adhesives in combination with LoctiteŽ 401, 406, 431, 454 and 4850 - use Activator LoctiteŽ 7458
Are you bonding "difficult to bond" rubber or plastic?
|
Yes
|
Solution:
406 (with Primer 7239)
Operating Temperature
Up to 80°C
Fixture Time*
10 - 20 sec.
Viscosity mPa.s
20
Especially for
Plastics
Pack Sizes
20g, 500g
* on steel
Are you bonding "difficult to bond" rubber or plastic?
|
No
|
Do any of the following apply? Is the gap over 0.1mm? Do you require a non-drip / non-run product?
|
If one or more apply
No
|
|
|
Is the bond going to be subject to shock or peel loads?
|
|
|
|
Yes
No
|
|
|
|
|
|
| | |
| | |
Bonding Flexible Materials
| | |
| | |
| | |
|
|
|
|
|
|
Solution:
454
480
4850
4062
401
431
Operating Temperature
Up to 80°C
Up to 100°C
Up to 70°C
Up to 80°C
Up to 80°C
Up to 80°C
Fixture Time*
5-20 sec.
6-120 sec.
5-20 sec.
3-20 sec.
5-20 sec.
5-20 sec.
Viscosity mPa.s
Gel
300
400
2
110
1,000
Especially for
Porous Substrates
Metal / Plastics
Flexible Substrates
Metal / Plastics
Porous Substrates
Porous Substrates
Pack Sizes
10g, 20g, 300g, 300g cartridge
20g, 500g
20g, 500g
20g, 500g
3g, 20g, 50g, 500g
20g, 500g
* on steel
If you would like to receive a copy of our LoctiteŽ Product Catalogue,click here
Murphy Engineers Limited, John F. Kennedy Ave, Naas Road, Dublin 12, Ireland
